Modern desktop computers are generally built in a way that makes it pretty easy for a knowledgeable user to upgrade them. Most people wouldn’t go so far as to try to remove the entire motherboard, but replacing parts like RAM and hard drives is straightforward and can be accomplished in a few minutes with only the most basic of tools. It would be a mistake, however, to assume that this same situation extends to laptops. If you’re experiencing a problem with one of those, you should stick with professionals for your Laptop Repair in Tucson AZ.
A laptop is built with a very different set of space constraints than desktops. Because the parts have to be fit into a far smaller space, while still leaving adequate room for ventilation, there’s very little room for error when someone is assembling them. Generally speaking, only the RAM and the battery of a typical laptop is designed to be accessed and swapped out by users, though there are some models that are specially designed to make other parts accessible. On the whole, this means that you have to do a lot more maneuvering to reach the component that might be giving you problems, and you’re likely to need more specialized tools to properly remove the pieces along the way.
Because laptops are not designed to be serviced by regular users, they also typically use parts that aren’t designed for safe handling. A hard drive or SSD drive that you would buy for a desktop is normally designed with its critical components covered to make it easier and safer to handle it. The much smaller M.2 SATA III SSD that is becoming popular in laptops leaves a lot more of the circuit board bare, which allows the part to be smaller but also means that it needs to be handled with more care. Smaller parts in general also have smaller pieces fastening them into place, and are generally more vulnerable to being broken by excessive force during installation.
Contact Rent-A-Techie if you need help with a Laptop Repair in Tucson AZ. They can help you to make sure that you’re getting the right parts for your model, and then they’ll make sure that everything is installed and working properly so that you don’t have to worry about someone making matters worse.
